Push 2 Cross Software Configuration​ Guide

Push 2 Cross Software Configuration Guide

Overview

This guide will assist you in setting up and configuring your Push 2 Cross system using the provided software. Follow these steps to ensure a successful installation and configuration of your system.

Configuration Steps

Step 1: Naming the Device

1. Enter Device Name:
   
   • Name your device based on its location. For example, "5th Street."
   • Choose a meaningful name for easy identification.

Step 2: Selecting Device Type

1. Choose Device Type:
   
   • Options include:
     
     • Audible Talking Button
     • Standard Button
     • Crosswalk with Overhead Illuminator
   • Select the appropriate type for your installation. For this guide, we will use a standard device.
2. Save and Continue.

Step 3: Setting Operating Mode

1. Select Operating Mode:
   • Options include:
     
     • Input Button Operated
     • Flash 24/7
     • Day Only Use
     • Night Only Use
   • Choose "Input Button Operated" for a standard setup.
2. Save and Continue.

Step 4: Configuring Brightness Settings

1. Adjust Brightness:
   • Default settings should suffice for most installations.
   • If adjustments are needed, configure brightness settings accordingly.
2. Save and Continue.

Step 5: Flash Pattern Settings

1. Choose Flash Pattern:
   • Options include:
     
     • Standard Flash
     • Pulse Flash
     • RRFB Flash Pattern (Recommended)
   • Select "RRFB Flash Pattern" for an alternating left-right flash pattern.
2. Set Hold Time:
   • Default is 10 seconds. Adjust based on the time needed to cross the street (e.g., 15 or 20 seconds).
3. Save and Continue.

Step 6: Adding a Collaborator

1. Add Collaborator:
   • Enter the Collaborator ID for the unit across the street.
   • Ensure the Collaborator ID is correctly entered.
2. Save and Finish:
   • The system will take a few moments to communicate and configure settings with the Collaborator.
   • Ensure antennas are installed and pointing straight up for optimal communication.

Step 7: Final Configuration

1. Verify Connection:
   • Ensure the system has found and set up the Collaborator.
   • Confirm by checking the LED indicators on the units.
2. Adjust Flasher Hold Time (if needed):
   • Navigate to the setup page.
   • Cycle through the configuration steps until you reach the flasher hold time setting.
   • Adjust as necessary and save changes.

Validation

1. Ensure Adequate Power:
   • Verify the system has 12.5 volts or greater to ensure proper operation.
2. Test Communication:
   • Ensure all antennas are properly installed and that units are communicating effectively.

Conclusion

You have now successfully configured your Push 2 Cross system. For any additional adjustments or troubleshooting, refer to the full manual or contact TraffiCalm customer support at 855-738-2722.